syrslr16
07-01-2011, 08:15 PM
It consists of two phases and the five-phase: the general two-phase step angle of 1.8 degrees and the general five-phase step angle 0.72 degrees. The most widely used Stepper Motor. 3. What is to keep the torque (HOLDINGTORQUE)? Holding Torque (HOLDINGTORQUE) refers to the stepper motor power but there is no rotation,digitized embroidery designs (http://www.eagledigitizing.com/), the stator locked rotor torque. It is the stepper motor one of the most important parameters,alphabet embroidery designs (http://www.eagledigitizing.com/), usually when the stepper motor torque at low speed near the holding torque. As the stepper motor's output torque increases with the speed and continuous attenuation,digitizing (http://www.eagledigitizing.com/), output power increases with the speed change,embroidery digitizing (http://www.eagledigitizing.com/), so keep the torque stepper motor to become a measure of one of the most important parameters. For example, when people say 2N.m the stepper motor in case of no special note is the holding torque of the stepper motor for the 2N.m.